|
Post by orbitalgolem on Oct 27, 2012 17:35:27 GMT -8
After 14 batteries today through the V120D02S doing front/back flips and loops galore, and suffering only one crash, I felt pumped to try my first couple of back flips with the V200D03. Whoa. Good thing I had a lot of altitude. She back flipped SLOWLY. I'm using stock pitch settings from the manual (+62%, -62% on the edges). 100% throttle across the board. I'm using the following settings: - Gyro pots at 1:00 when facing the RX with all the text right-side up.
- ELEV/AILE EXT at 2:30
- Using Futaba 3114 servos
- LINE (linear) for ELEV, AILE, and +5% EXPO on RUDD
- 100% D/R for everything
- -100% to 100% travel adjust for everything
Any ideas for speeding up the flip rate? Is the ELEV/AILE EXT too low at the 2:30 setting?
|
|
|
Post by majic1 on Oct 29, 2012 13:01:37 GMT -8
Have you made any changes to your trim pots or is that the way they came? I have to look at mine and compare it to your pot settings. I don't remember where mine are set off the top of my head. The default pot settings are set to be very tame for beginners. You have to turn the pots down to reduce to gyro effect. Also, you might want to try turning down your gyro mix switch a notch. I would also turn your expo's down to '0' or even '-10'.
I'll check my trim pots and get back to you when I have more time.
Just curious, but is there a reason you put the Futaba 3114 analog servos on the V200 instead of the 3156 digital/metal gear servos?
|
|