Post by JR Moltz on Dec 15, 2014 12:46:26 GMT -8
Hello,
Is there a list of instructions, regarding replacing motors and esc's and then re-calibrating? I am having a problem with getting the #2 motor to run.
the #2 motor on my Walkera X350 Pro stopped working after a recent crash.
I replaced the motor, but it also did not work. So I replaced the esc and tried to re-calibrate the esc's, this still does not fix the problem. I connected a volt meter to the red and black leads going to the esc and it registered current while in the calibration mode. Red LED lights come on the esc but then go off while 3 other motors engage and LED's stay on for those esc's. Rechecked and re-did my solder connections and seem fine.
I also switched out the esc wires going into the control module. All motors worked in all 4 positions, except the #2 motor not working in any.
For calibrating I tried:
TX throttle set to full 100%, then turn on.
Battery connected on quad. Rear LED's Light alternate left to right.
Disconnect battery, then reconnect. Rear LED's Light alternate left to right.
Move throttle all the way down to 0% then up to 100%. #1, #3 & #4 motors engage LED's light and stay on as accelerate, #2 motor LED's light and then turn off as the motor does nothing.
Am I missing something painfully obvious?
Is there a list of instructions, regarding replacing motors and esc's and then re-calibrating? I am having a problem with getting the #2 motor to run.
the #2 motor on my Walkera X350 Pro stopped working after a recent crash.
I replaced the motor, but it also did not work. So I replaced the esc and tried to re-calibrate the esc's, this still does not fix the problem. I connected a volt meter to the red and black leads going to the esc and it registered current while in the calibration mode. Red LED lights come on the esc but then go off while 3 other motors engage and LED's stay on for those esc's. Rechecked and re-did my solder connections and seem fine.
I also switched out the esc wires going into the control module. All motors worked in all 4 positions, except the #2 motor not working in any.
For calibrating I tried:
TX throttle set to full 100%, then turn on.
Battery connected on quad. Rear LED's Light alternate left to right.
Disconnect battery, then reconnect. Rear LED's Light alternate left to right.
Move throttle all the way down to 0% then up to 100%. #1, #3 & #4 motors engage LED's light and stay on as accelerate, #2 motor LED's light and then turn off as the motor does nothing.
Am I missing something painfully obvious?